MT3401E.doc rev.0
21/05/13
Pagina 77 di 86
OR
OR Mode. The output gets activated whenever one of the events associated to
this output enters an alarm or failure condition.
Voting
A settable quantity of events would happen at the same time to activate
the output.
Associated Sensors /Modules
it is the window where the events associated to the
output can be chosen (with the Add/Remove key) and shown.
Add / Remove
To add or remove the events from the
Associated Sensors Modules
window.
Programming of a new Relay Output
Selecting the new output, by the Relay Type mode select if it is a Sensor event, a
Module event or a Generic event.
Sensor event
: select
Sensor
in
Relay Type.
Then go to the
Event Type
and select the
type of the activation between:
Underscale
,
Alarm1
,
Alarm2
,
Alarm3
,
Overange
,
Overscale
and
Fault
.
Fig. 4.5.6 d) Sensor event
By pushing
Add / Remove
, the screen will allow you choose the channel address or the
input channels (to be associated to an output).
An open or closed lock on the left side is indicating the non latching or latching status of
the relay output.
