Do not use the appliance for other than intended use, this is for HOUSEHOLD USE ONLY.
Electrical Safety
Read these instructions thoroughly before using this appliance or connecting it to the mains supply.
A 13 amp BS1362 ASTA approved fuse must be fitted.
This appliance must be earthed.
Before switching on, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate. Connecting it to any other power source may cause damage.
There are no user-serviceable parts inside this appliance. Always refer servicing to qualified
service personnel. The mains lead of this product is not replaceable by the user. If the
mains lead is damaged, discontinue use immediately and do not use until the appliance has
been inspected and approved by a qualified electrician.
Do not allow this product to be exposed to rain or moisture during use or storage.
Before switching on, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate. Connecting it to any other power source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to change the fuse
in the plug, the fuse cover must be refitted. If the fuse cover becomes loose or damaged,
the plug must not be used until a suitable replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or due to damage,
it should be cut off and a replacement fitted, following the wiring instructions shown.
The old plug must be disposed of safely because inserting it into a 13 amp socket could
cause an electrical hazard.
The wires in the power cable of this product are coloured in accordance with the following code:
Blue = Neutral Brown = Live Green/Yellow = Earth
If the markings on the terminals of your plug do not correspond to the colours of the wires in the
power cable, proceed as follows:
•
The wire which is coloured
Blue must be
connected to the terminal which is marked
N
or coloured
Black.
•
The wire which is coloured
Brown must be
connected to the terminal which is marked
L or
coloured
Red.
•
The wire which is coloured
Green/Yellow must
be connected to the terminal which is marked
with the earth symbol ( ) or coloured Green.
2
