5
Technical Support: +31(0)20 613 1611
PAK200581_01N October 2015 ©2015 SenseTek B.V.
WARNING: ALWAYS FIT 2 BATTERIES and wire in series,
the product will NOT work with a single 12 V battery
Fit 2 x 12V
7 Ah batteries
Mounting
Points
Fit 2 x 12V
17/18 Ah batteries
4)
All cabling should be securely fastened in position using a cable tie through the saddles provided.
Mounting – C Box – 7 Ah
5)
The C box is designed to support two 7 Ah batteries, and as such weighs a total of 9 Kg when loaded.
Ensure that wall fixings are appropriate to support this weight.
Mounting – E box – 17 or 18 Ah
6)
The E box is designed to support two support two 17 or 18 Ah batteries, and as such weighs 18.5 Kg when
loaded. Ensure that wall fixings are appropriate to support this weight. The product should be mounted no
further than 10 cm from the control and indicating equipment, close coupled by conduit if it is being used
to power the CIE directly.
7)
Fix to wall or other structure in correct orientation i.e. with hinge on left hand side, using screws of
sufficient size and length through the mounting holes.
8)
Protect the battery terminals from any metal surfaces during installation as shorting of the terminals is
hazardous.
9)
Knock-outs are provided in the case for mating with external trunking or conduit.
10)
Ensure that all unused holes (on the rear of the case) are sealed to prevent the ingress of damp and dust.
Figure 1 – Box Mounting “E” Enclosure
“C” Enclosure
Figure 2 – Battery fitting and assembly
