13
press and hold the Inclusion button (item #1 on page 5) on the Commander until the
In/Exclusion LED start blinking in red. This allows the Commander to enter into
“inclusion mode” for 30 seconds.
5.
Secondly, on the Z-Wave device, configure the device into ‘inclusion mode’ by
pressing and releasing the programming / inclusion / tamper switch quickly 3
consecutive times.
6.
If the device is successfully paired with the Commander, the In/Exclusion LED will
stop blinking in red.
7.
Return to the main menu, and click on ‘View Events’, the newly added device will be
shown.
8.
To rename the device to give it a more meaningful name (i.e. Lobby Motion Sensor),
click on the ‘Edit Alias’ button. When completed, click on the ‘X’ to exit.
9.
If necessary, repeat Step 2~8 above to include additional Z-Wave devices.
10.
If inclusion attempt failed, please perform the exclusion procedure in the following
section. Then, repeat Step 2~8 above again to include the Z-Wave device.
