Sennheiser SKM 9000, Инструкция по эксплуатации

Страница: 50 / 109

Digital 9000 | 49
Using the EM 9046
“ sys ” operating mode – Configuring the system
In “ sys ” operating mode, you can configure the transmitters and the
receiver.
Overview of the “ sys ” menu
Main menu “System setup” Page
Frequency scan Performs a frequency scan 50
Audio output level Adjusts the output level 54
Word clock Configures the word clock 55
Cable attn Displays the cable attenuation
between booster output and
RF input of the EM 9046 55
Load config Loads a configuration 56
Save config Saves a configuration 56
Network Configures the network 57
Brightness Adjusts the brightness 57
Service setup
Calls up the extended menu
“
Service setup ”
–
Extended menu “Service setup” Page
System setup
Calls up the main menu
“
System setup ”
–
Factory reset
Loads the factory default
settings
58
Date & time Adjusts the date and time 59
Op hours Displays the operating hours 59
Log Displays the event logs 60
System check Displays the system status 60
HW setup
Displays the hardware configu-
ration and status
60
Firmware Displays the firmware versions
and updates the firmware of the
transmitters and boosters
63