Sennheiser NET 1, Инструкция по эксплуатации

Страница: 26 / 32

26
If a problem occurs ...
Problems that may occur when putting the NET 1 into operation
Problem Possible cause Possible solution
The green “READY” LED has
gone off.
The power cord is not connected
correctly. Check if the power cord is connected
correctly.
The NET 1 is switched off. Press the ON / OFF switch on the rear
panel (see page 9) to switch on the
NET 1.
The green “CHANNEL” LED
does not light up, even though a
device is connected.
The cable of the corresponding device
is not connected correctly. Check if the cable is connected
correctly.
The rack-mount device of the evolution
wireless G2 series is switched off. Switch on the rack-mount device.
The cable between the NET 1 and the
rack-mount device is defective or the
connector assignment is incorrect. Only use original Sennheiser cables.
Replace the cable or check the
connector assignment (see “Connector
assignment” on page 28).
The corresponding connection group is
double-occupied:
Devices are connected to the sub-D
socket and to the RJ 10 sockets.
Either remove the device connected to
the sub-D socket or the devices
connected to the RJ 10 sockets (see
“Connecting the devices” on page 13).
One of the receivers RX 1 or RX 2 of the
connected EM 3532 twin receiver is not
being detected due to the fact that the
receiver was switched off when the
NET 1 was switched on.
왘
Switch off the NET 1.
왘
Switch on both receivers RX 1/RX 2
of the EM 3532 twin receiver.
왘
Restart the NET 1 (see “Restarting
the NET 1” on page 27).
The green “READY” LED
flashes.
The NET 1 is being initialized (duration:
approx. 20 sec.) and is not yet ready
for operation. Wait until the “READY” LED lights
up permanently, indicating that the
NET 1 is ready for operation.
The green “CHANNEL” LED
flashes once every second.
The firmware of the connected device
is
not compatible.
Update the firmware of the device (see
the Instructions for use of the
“Wireless Systems Manager”
software).
The assignment of the channel
buttons to the channels of the
EM 3532 twin receiver is
swapped. Instead of the receiver RX 1, the
receiver RX 2 is connected to sub-D
socket on the NET 1. Connect the receiver RX 1 to the sub-D
socket on the NET 1 (see “Connecting
an EM 3532 twin receiver” on
page 14).
The NET 1 does not react. Restart the NET 1 (see “Restarting the
NET 1” on page 27).
The yellow “REMOTE” LED
does not light up.
Communication between the NET 1 and
the PC is disturbed. Check the connections and cables as
well as the PC settings.