Sennheiser evolution wireless G3 EM 100, Инструкция по эксплуатации

Страница: 20 / 59

Using the receiver
19
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the receiver’s RF level display
“
RF ” reacts.
If you cannot establish a transmission link between transmitter and
receiver:
왘
Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.
왘
Read the chapter “Synchronizing transmitters with receivers” on
page 42 and, if necessary, the chapter “If a problem occurs ...” on
page 47.
Switching the receiver on/off
To switch the receiver on :
It is vital to observe the notes on frequency selection on page 42.
왘
Briefly press the STANDBY button .
The receiver switches on and the “ Receiver Parameters ” stan-
dard display appears.
533.875
ew100 G3 20.12
MHz
SET
P
PEAK
-10
0 40
25
10
-20
-30
AF
RF