Putting the devices into operation
11
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s flash mount.
Determine where on the perforated plate
the flash mount adapter
will need to be
fastened so that the receiver can best be attached to the camera.
At this position, place a square nut
under the perforated plate
.
Fasten the flash mount adapter
to the perforated plate
using the square nut
.
Lift one side of the belt clip
as shown.
Press down the belt clip
at one fixing point and pull it out of the receiver housing.
Repeat for the other side.
Place the perforated plate
onto the rear of the receiver.
Reinsert the belt clip
.
Use one of the supplied line cables to connect the line input of the camera to the
socket
.
The shield of the line cable serves as the antenna for the second diversity section.
ew 100 P G3 Set _529660_0309_Sp9.book Seite 11 Mittwoch, 8. April 2009 6:57 18