Sennheiser EK 300 IEM, Инструкция по эксплуатации

Страница: 52 / 160

50
To mount two transmitters into a rack:
Place the two transmitters side by side onto a flat
surface, their bottom sides facing upwards.
Align the connecting plate
$
over the holes in the
bottom sides of the transmitters.
Secure the connecting plate
$
using eight of the
supplied recessed head screws (M 3x6).
Hook the two rack mount “ears”
"
to the front panels
of the transmitters.
Secure the rack mount “ears” to the transmitters
using two of the supplied recessed head screws
(M 3x6) respectively.
Slide the transmitters into the 19” rack.
Secure the rack mount “ears” to the rack.
When mounting only one transmitter into a rack, use the
connecting bar
#
instead of the second transmitter.
Hook the two rack mount “ears”
"
to the front panels
of the transmitter.
Secure the rack mount “ears” to the transmitter using
two of the supplied recessed head screws (M 3x6)
respectively.
Secure the connecting bar
#
to one of the rack mount
“ears”
"
using two of the supplied recessed head
screws (M 6x10).
If you are not front mounting the antennas, insert the
two covering plugs
%
into the antenna holes of the
connecting bar.
Slide the transmitter into the 19” rack.
Secure the rack mount “ears” to the rack.
To mount the transmitter’s antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
Screw the BNC socket
&
of the BNC extension cables
to the connecting bar
#
using the supplied plain
washer and nut.
Connect the BNC connector
'
to the BNC socket at
the rear of the transmitter.
Slide the transmitter into the 19” rack.
Secure the rack mount “ears” to the rack.
Connect the telescopic antenna to the BNC
socket
&
.
Pull the end cap to extend the telescopic antenna.
"
"
$
#
"
"
%
&
#
'