Senix CSPE6.5-M, Руководство оператора

Страница: 12 / 64

12 WWW.SENIXTOOLS.COM
HANDLING POLE SAW
• Hold the Pole Saw with both hands using the soft
grip.
• Fully grip both handles at all times during operation.
• Hold the Pole Saw at a max. angle of 60° from the
horizontal level.
• Maintain a minimum distance of thirty feet to
bystanders.
Do not operate Pole Saw using only one hand.
Do not stand directly under the limb you are sawing.
Objects may fall different than expected. Position
yourself well out of the path of falling limbs. Keep
bystanders away from cutting end of garden power tool
and a safe distance from the work area.
Do not stand on a ladder or other support while using
Pole Saw.
WARNING:
WARNING:
WARNING:
ATTACHING THE EXTENSION CORD
Open the quick release clamp if it is necessary to open
the harness quickly.
You should only use extension cords for outdoor use,
PVC or rubber cord ordinary duty with a cross sectional
area not less than 1.5 mm. Before and during use,
check the supply and extension cords for damage. Do
not use the appliance if the cord is damaged or worn.
Keep extension cord away from cutting elements. If the
cord is damaged during use, disconnect the cord from
the supply immediately. Do not touch the cord before
disconnecting the supply.
WARNING:
HOLDING THE UNIT
AVOIDING KICKBACK DURING USE
Remove the plug safety cap. Insert the extension cord
socket into the pole saw plug. An extension cord retainer
is attached to the handle to reduce strain on the cord.
To use the cord retainer, double the extension cord as
shown, about a foot from the end, and insert it into the
end of the retainer. Place the
loop formed by doubling the cord over the hook. Gently
tug on the cord
to ensure that it is firmly situated in the retainer.
Keep the extension cord clear of operator, unit, and any
obstacles at all times. Do not expose the cord to heat, oil,
water, or sharp edges.
When kickback occurs, the pole saw can react
unpredictably and cause severe injures to the operator
or bystanders.
To avoid kickback:
Kickback occurs when the chain (at the tip of the guide
bar) comes in contact with a log or wood, or when
the saw chain becomes jammed, often when sawing
sideward, slanted or during lengthwise cuts.
WARNING:
• Stand in the operating position Stand up straight. Do
not bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right
arm slightly bent.
• Hold the handle with the left hand. Keep the left arm
straight.
• Hold the unit at waist level.
• Saw with guide bar at a flat angle
• Do not work with a loose, overstretched or worn out
chain
• Ensure chain is sharpened correctly
• Do not work with the tip of the guide bar
• Hold the pole saw firmly with both hands
• Use a low kickback chain
• Ensure correct chain tension.
• Position the cutting head a few inches above the
ground.
• Do not over-reach; Keep all parts of your body away
from the rotating cutting attachment and hot surfaces.