Senix CSE10-L, Руководство оператора

Страница: 13 / 65

12 WWW.SENIXTOOLS.COM
FILLING THE AUTO OIL SYSTEM
ATTACHING THE EXTENSION CORD
CAUTION!
CAUTION!
The chain saw is
NOT
supplied filled with
oil. It is essential to fill with oil before use.
Never operate the chain saw without chain
oil or at an empty oil tank level, as this will
result in extensive damage to the product.
Chain life and cutting capacity depends on
optimum lubrication. Therefore, the chain is
automatically oiled during operation via the
oil outlet.
To prevent oil leakage, ensure machine is left
in a horizontal position (oil filler cap upright)
when not in use. Use only the recommended
oil to avoid damage to the chain saw. Never
use recycled/old oil. Use of non approved oil
will invalidate the warranty.
Remove the plug safety cap (Fig. 5). Insert
the extension cord socket into the chain saw
plug.
This chain saw features an auto-oiling system
to keep the chain and chain bar properly
lubricated. The oil level indicator shows the
remaining oil in the chain saw. If the oil level
decreases to below one quarter capacity, refill
it with the proper bar and chain oil.
To fill the oil reservoir:
1. Remove the oil cap (Fig. 4). Fill the
reservoir with bar and chain oil (SAE30)
until the oil level has reached full capacity.
2. Put the oil cap back on. Make sure to
check the oil level after every 10 minutes of
use. Unplug the chain saw before checking
oil levels or filling the oil reservoir.
Fig. 3
Blade screwdriver
decreases tensionwith the blade
screwdriver. A properly tensioned chain
should have no sag (Fig. 3) and should
only be able to be pulled 1/8 inch (3 mm)
away from the chain bar of the saw.
4. Once the chain is properly tensioned,
tighten the end cover nut. DO NOT over-
tension the chain: this will lead to excessive
wear and reduces the life of both the bar
and chain.
NOTE:
The saw chain must be tensioned
properly in order to ensure safe
operation. The chain tension is optimal
if the saw chain can be lifted 1/8
inch (3 mm) from the center of the
chain bar. Since the saw chain heats
up during operation, its length can
therefore fluctuate. Check the chain
tension every 10 minutes of operation
and adjust as necessary, particularly
for new saw chains. Slacken the saw
chain after the work is completed
since it shortens when cooling down.
In doing so, you can increase the
chain’s life and prevent damage.
1/8” (3 mm)
Fig. 1
Fig. 2