7.
Input the access password which is as the router Wi-Fi router, click “Next” to
enter the Next step. At this point, APP will send multicast to make the lamp of
the Factory Settings is connected to the root router, and the program will search
out these lamps. The names of these lamps apply their MAC address the name of
the last two as a suffix, and display them on the interface for users to choose
whether to access the network.
If there is no any equipment, please check if the lamp is powered on, and click
the refresh button to try again.
8.
The App will also search and list out nearby available boost A01-A60 bulb/s.
The default SSID of the bulb is “SENGLED_AP”. (ATTENTION: Figure shows
below, SSID Name of "LL_AP_00_**" only for engineering samples demo).
Press the “Start” tab for configuring all chosen boost A01-A60 bulbs. And the
lamps which are not chosen restore to the initial state of factory Settings. If
the root router is encrypted, the initialized bulb is also encrypted with a
default password of "12345678". Input the bulb password and wait for the
configuration process complete.
9.
After the process of bulb network configuration has been succeeded, boost
A01-A60 bulb/s will reboot (THIS PROCESS MAY TAKE FEW MINUTES, PLEASE
BE PATIENCE). Press “Done” and return to the home page. If the configuration
failed, refresh the configuration to networking again.
10.
The App begins to search the configured online LED bulb/s. (SINCE THE BULB
REBOOT PROCESS MAY TAKES FEW MINUTES, PLEASE BE PATIENCE AND
REFRESH THE LIST FROM TIME TO TIME). After searching out all configured
