ENGLISH 4/7
5 INSTALLATION STANDARDS
The module has been designed for vertical installation on an IEC EN 60715 DIN rail. For optimal
operation and long working life, adequate ventilation must be provided. Avoid positioning cable ducts or
other objects so that they obstruct the ventilation slots. Avoid mounting modules over equipment
generating heat. Installation in the bottom part of the distribution board
is recommended.
OMEGA IEC EN 60715 guide installation and removal.
Insertion into the IEC EN 60715 guide:
1) Move the two hooks on the back of the module
outwards as illustrated in fig. 1b.
2) Rest the module on the IEC EN 60715 DIN
guide.
3) To secure the module to the IEC EN 60715
DIN rail, tighten the two hooks on the side of the
IDC10 rear connector as shown in fig. 1a.
Removal from the IEC EN 60715 guide:
As shown in figure 1b:
1) Move outwards the two hooks on the side
of the module, with the help of a screwdriver.
2) Extract the module from the guide.
Use of Z-PC-DINAL2-17.5 accessory
If Z-PC-DINAL2-17.5 accessory is used, the
power supply and communication signals may
be provided by the terminals block into the DIN
rail support. The figure shows the meaning of
the terminal blocks and the position of the DIP-
switch in the Seneca IEC EN 60715 DIN rail
accessory.
GNDSHLD: Shield to protect the connection
cables against interference (recommended).
IDC10 rear connector
The IDC10 connector located on the rear of the
module will be inserted on a free slot of Z-PC-DIN
accessory. In the figure you can see the meaning
of the IDC10 connector pins if you want to provide
signals through them. The IDC10 connector
provides the COM 2 RS485 port.
MI00367
-3
-E
