ENGLISH - 3/8
1 - Attach the module in the upper part of
the rail.
2 - Press the module downwards.
1 - Apply leverage using a screwdriver (as
shown in the figure).
2 - Rotate the module upwards.
Assembly in vertical position is recommended in order to increase the module's
ventilation, and no raceways or other objects that compromise aeration must be positioned
in the vicinity.
Do not position the module above equipment that generates heat; we recommend
positioning the module in the lower part of the control panel or container compartment.
RTD wiring
50 / 60 Hz Rejection filter
Reversed Output
RTD Type
Measurement Range Start
Measurement Full- Scale
Output signal in case of
Fault
Over-Range
3 wires
present
NO
PT100
0 °C
100 °C
Towards the top of the output range
YES: a 2.5% over-range value is acceptable;
a 5% over-range value is considered a fault.
MI00124 -E
2
SETTING BY DIP-SWITCHES
Configuration from memory
The module leaves the factory with all the DIP-switches in OFF position.
In this position the module uses the configuration saved in memory. This configuration may
be modified by PC (see
section).
Setting by PC
The default configuration is the following (if no other indications are present on the
instrument):
MODULE CONFIGURATION
The module may be configured both by DIP-switches and by PC.
If only a DIP-switch is not in OFF position, the configuration saved in memory is not used (it
K
1
2
0
R
T
D
K120RTD
Inserting the module in the rail
Removing the module from the rail
Installation rules
This module has been designed for assembly on a DIN 46277 rail.
