EN-10
EN
2 in 1 Cordless Vacuum Cleaner
SVC 7612VT / SVC 7614TQ
2015
09/2015
MAINTENANCE AND CLEANING
•
Before cleaning it, always check that the vacuum cleaner is turned off and disconnected from the
el . power source .
Cleaning the dust collection container
•
Remove the dust collection container A
0
from the hand vacuum cleaner . Take the motor protection
filter A
qj
and the coarse particle filter A
qk
out of the container A
0
. Remove dust and dirt found
above the basket from the container A
0
. Use a fine brush to clean the suction opening A
qh
.
•
Remove dust and dirt from filters A
qj
and A
qk
. In the event of heavy soiling, both filters A
qj
and
A
qk
may be washed under running water with the use of a neutral kitchen detergent . Allow filters
A
qj
and A
qk
to dry freely and then assemble the vacuum cleaner according to the instructions
contained in the chapter Assembling the vacuum cleaner . Before returning filters A
qj
and A
qk
to
the collection container A
0
, make sure that they are completely dry .
Attention:
To prevent damaging the vacuum cleaner, make sure that the filters A
qj
and A
qk
are properly
installed in their place before starting the vacuum cleaner .
•
In the event that the motor protection filter A
qj
shows signs of wear, replace it with a new one . To
order it, please contact an authorised service centre .
Cleaning the floor nozzle and attachments
•
Take the floor nozzle A
qs
off the body of the vacuum cleaner A
6
. Turn it over so that the rotary
brush is pointing upwards . On the right side of the nozzle A
qs
the rotary brush is secured with
a locking screw . This needs to be released using a flat screwdriver by turning it in the direction of
the open padlock symbol .
G
1
1
Rotary brush locking screw
•
Take the locking screw and rotary brush out of the floor nozzle A
qs
. Remove all dirt and dust from
the rotary brush and the internal space of the floor nozzle A
qs
. After cleaning, return the rotary
brush and locking screw back in their place . Turn the locking screw in the direction of the closed
padlock to fasten the rotary brush .
•
For cleaning the surface of the floor nozzle A
qs
and the attachments A
wa
and A
ws
use a dry or
a lightly dampened cloth . Then wipe everything so that it is thoroughly dry .
