Sencor SPT 3907, Руководство пользователя

Страница: 7 / 68

EN - 5
NOTE:
In CD/USB/MP3/AUX mode, when the unit is not providing the main function for 15 minutes, the unit
will automatically switch into standby mode. In the tape mode, only the tape stops for 15 minutes, the
unit will automatically switch into standby mode. To turn on the unit again, press „ STANDBY/FUNC.“
button or replug the unit.
ESD hints – The product maybe reset or not reset to operation of control due to electrostatic dis-
charge, just switch off and reconnect again.
TO ADJUST VOLUME
Press VOL.+/- button to increase or decrease volume.
HEADPHONE JACK
For private listening, connect a 3.5mm headphone (not included) to the HEADPHONE jack. The
SPEAKER will be automatically disabled.
CAUTION :
LISTENING AT A HIGH VOLUME OVER A LONG PERIOD IS NOT GOOD FOR YOUR EARS.
USING THE RADIO
TUNING IN RADIO STATIONS
1. Press the STANDBY/FUNC. button to choose radio mode: FM mode.
2. Tune to the desired station by pressing  or  button, the station frequency will show on the
display.
3. Press the VOL.+/- button to adjust the volume to a comfortable level.
4. To optimize reception when listening to stations on the FM band, extend the telescopic antenna to
its full length. Gently move the unit back and forth to get the best reception when you are listening
to FM program, or place the unit in an open place. When the stereo signal is received, the ST.
show on the display.
AUTO PRESET MEMORY / SCAN
To search for and automatically save stations to preset memory, press and hold the PLAY/PAUSE
button. Any station with a strong enough signal will be saved to preset memory.
After the unit finishes scanning, the unit will automatically tune to preset station number 1 (P01).
To tune to the next or previous preset station, press M.+/M.- button to go to next or previous preset
station.
MANUAL PRESET MEMORY OPERATION
You may pre-store 30 radio stations in memory for your preference.
1. Tune to the desired station that you want to save as a preset by pressing  or  button.
2. Press the PROG. button on unit, PROG indicator will flash and “P01” will show on the display to
indicate that you are saving the station as preset memory 01, to change the preset memory se-
quence, press M.+ or M.- button., then press PROG. button on unit again to enter.
3. Search another station, repeat steps (1) & (2) until all desired stations stored. Up to 30 FM stations
can be programmed.
4. To tune to the next or previous preset station, press PROG. button first, then press M.+ or M.- bu-
tton immediately to go to next or previous preset station.