Microwave oven
SMW 6020SS
EN
EN-11
2021
05/2021
GROUNDING INSTRUCTIONS
This microwave oven must be grounded. The microwave oven is equipped with a power cord, which has a grounding
wire with a grounded power plug. The power plug must be connected to a power socket, which is properly installed
and grounded. Grounding reduces the risk of electrical shock. In the case of a short circuit, the electric current is
conducted though the grounding wire. We recommend that the oven be connected to an independent electrical circuit.
Warning:
An incorrectly grounded power socket may present a danger of electrical shock.
Note:
If you have any questions regarding grounding or electrical instructions, consult all such matters with
a qualified electrician or repair person.
Neither the manufacturer nor the vendor take any responsibility for whatever damage to the oven or injury
resulting from an incorrect electrical connection.
RADIO WAVE INTERFERENCE
The operation of the oven may cause interference to a radio, television or similar devices. If you register any interference,
perform the following steps to limit or entirely eliminate the interference:
1. Clean the door and the door gasket seals.
2. Move the radio or television antenna to a different location.
3. Point the microwave oven away from the receiver.
4. Move the microwave oven farther away from the receiver.
5. Connect the power plug of the microwave oven into a different power socket so that the oven and the receiver
have their own separate electrical circuits.
USING THE MICROWAVE OVEN
Prior to use, check that the turning tray carrier
A4
and turning tray
A7
are correctly installed.
Note:
The turning tray
A7
must turn freely when the microwave oven is in operation.
When the power plug is inserted into the power socket, a sound is made and the time “1:01” and icon “
” appears on
the display. This means that is necessary to set the clock. Proceed according to the instructions in section “
Setting the
clock
” below in this user’s manual. Nevertheless, it is also possible to control the microwave oven without the clock
being set, however, in order to use certain programs in real time, it is necessary to set the actual time.
In the event that while the microwave oven is being set a pause longer than 20 seconds occurs, the settings will be
interrupted and the oven will switch to the stand-by mode. It will be necessary to re-enter the settings.
In the event that you need to set the cooking/heating status while the microwave oven is running, short press button
B7
. The operation of the microwave oven will be paused. To continue operation, short press the knob
B6
, to cancel
the cooking/heating process, press button
B7
one more time.
When the cooking / heating process is finished, the display
B5
will show “End” and the appliance will beep, which will
be repeated every 2 minutes until button
B7
is pressed of the door is opened.
The backlight of the display
B5
will be dimmed in the stand-by mode and in the child safety lock mode approximately
1 minute after the last setting is performed or button is pressed. The brightness of the display
B5
is renewed when
any button is pressed or when the door is opened or closed.
The microwave oven is equipped with an electronic cooling control system. This system automatically starts the fan
located inside the microwave oven when the cooking / heating time exceeds 2 minutes and will remain in operation
