EN-8
EN
Hair Clipper
SHP 3301BL / SHP 3302RD / SHP 4301BL / SHP 4302RD
2016
05/2016
C
•
Turn on the hair clipper by sliding switch A
6
to the ON position.
Attention:
The cutting unit A
1
will cut off all hair that comes into contact with it, therefore be especially
careful when handling the hair clipper while it is running.
•
Cutting without the comb attachment A
2
is used primarily for trimming up sideburns and the ear
line and the nape of the neck. When trimming the ear line, hold the hair clipper so that the blade
of the cutting unit A
1
points downwards ensuring that only the cutting blades are in contact with
the hair. When trimming the line at the nape of the neck, hold the hair clipper so that the blade
of the cutting unit A
1
points downwards. Touch the skin with the cutting blade only very lightly.
•
When you have finished using the hair clipper, turn it off by moving switch A
6
to the OFF position
and clean it out according to the instructions in the chapter ‘Cleaning and Maintenance’
2.2 TRIMMING A BEARD
•
Proceed in the same way as when cutting hair. Trim the beard when it is dry without the use of
shaving gels or foams.
•
Trim the beard by slowly moving against the growth direction of the beard, going from the bottom
upwards.
CLEANING AND MAINTENANCE
•
Before starting to clean the hair clipper, make sure that it is turned off and disconnected from the
power socket.
•
Regular cleaning after every use will ensure optimal performance of the hair clipper.
Attention:
This hair clipper is not designed to be washed under the water tap. Do not spray the hair clipper or
the power adapter A
8
with water or any other liquid or submerge it in water or any another liquid.
CLEANING
•
Remove the comb attachment A
2
from the cutting unit A
1
if attached. Hold the hair clipper in your
hand so that your thumb is located on the cutting blade. Use your thumb to push the cutting blade
from the body of the hair clipper A
3
until the cutting unit A
1
is completely released. Take the cutting
unit A
1
off the body of the hair clipper A
3
. Use the brush A
9
to remove all hair or beard remains
from the cutting unit A
1
and from the area of the body of the hair clipper A
3
underneath the cutting
unit A
1
. After cleaning, reattach the cutting unit A
1
to the body of the hair clipper A
3
. Position the
cut-out at the foot of cutting unit A
1
against the notch on the body of the hair clipper A
3
and then
push the cutting unit A
1
onto the body of the hair clipper A
3
until there is an audible click.
