EN - 3
Detaching and attaching the front panel
The front panel of this unit can be detached in order to prevent the unit from being stolen.
FOLDING DOWN AND DETACHING/ATTACHING THE FRONT PANEL
Before detaching the front panel, be sure to press the
button (1) OFF fi rst.
Then press the
button (16), let the Front Panel arrive in horizontal position and detach the panel by pulling it towards you as illustrated.
2
1
Notes:
• Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly against the unit.
• When you carry the front panel with you, put it in the supplied front panel case.
• Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit.
Rear of
front panel
Main unit
Cotton Swab
CLEANING THE CONNECTOR
The unit may not function properly if the connectors between the unit and the front panel
are contaminated with dirt. In order to prevent this from happening, detach the front panel
by pressing the
button and clean the connector from time to time.
Clean the connector with a cotton swab together with contact cleaner as illustrated. Be sure
to clean them carefully pin by pin and make sure not to damage the connecting points.
OPERATION
1. POWER ON/OFF (
)
By pressing this key, the unit is on or off.
This unit is turned on by pressing any key.
2,3. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER/TA SEEK/MASK DPI/RETUNE/AUDIO DSP/LOUDNESS/SUBWOOFER/CD MULTI/BEEP/
SEEK/STEREO/LOCAL/VOL LAST (SEL)
Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the VOL (3) knob shortly until
the desired functions is shown on the display. Figure 1 shows how control functions are selected using the VOL knob.
1
3
2
4
2
5
2
6
2
2
1. VOL
2. SEL
3. BAS
4. TRE
5. BAL
6. FAD
Fig. 1 Selection of sound control functions
Turning the VOL knob Right or Left. Increase or decrease the volume by turning
VOL
or
VOL
. These buttons can be used to adjust the BASS,
TREBLE, BALANCE and FADER.
TA SEEK/TA ALARM (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function.
TA SEEK Mode or TA ALARM mode is selected by
VOL
or
VOL
.
TA
SEEK
SEL
2 sec.
TA
SEEK / TA ALARM
VOL
- TA SEEK mode:
When newly turned station does not receive TP information for 5 sec., the radio retunes to next station which has not the same station (PI) as the
last station, but has the TP information.
In TA seek mode, the current station can be changed to the completely different station because the unit searches TP station when the fi eld
strength of the current station is very weak, or the current station has no TP signal.
- TA ALARM mode:
Any automatic retune mode is not activated, just can hear Beep sound.
MASK DPI (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of these function.
2 sec.
TA SEEK
SEL
MASK DPI
SEL
2 sec.
MASK DPI / MASK ALL
VOL
MASK DPI: masked only the AF which has different PI.
MASK ALL: masked the AF which has different PI and NO RDS signal with fi eld strength.
<10˚
Содержание SCD-5045MR
Страница 2: ......
