EN - 2
ISO CONNECTOR
CONNECTOR A
4. MEMORY
+12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
ANTENNA
CONNECTOR
L (WHITE) R (RED)
L (WHITE) R (RED)
LINE OUT
LINE IN
ISO CONNECTOR
SUBWOOFER
TEL MUTE (BLACK)
FUSE 10A
Note:
(connector A no. 7) must be connected by car ignition key in order to avoid that car battery becomes weak when the car will be not used for long
period.
CONNECTOR B
1
.
REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the replacement, there may be an internal malfunction.
In this case, consult your nearest repairing center.
Warning
Use the specifi ed amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
INSTALLATION
PRECAUTIONS
• Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be
subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Be sure to remove the front panel before installing the unit.
NOTE:
Inclination angle for car radio installation must not exceed 30˚ otherwise the front panel will not open.
Bend these claws,
if necessary
3
2
182mm
53mm
1
2
1
3
4
release screw and
bracket
Note:
Keep the release key in a safe place as you may need it in future to remove the unit from the car.
TO SUPPORT THE UNIT
10
7
1
2
3
4
4
4
5
5
6
6
8
9
Dashboard
1. UNIT
2. RELEASE
CASE
3. DASH
BOARD
4. HEX
NUT
5. LOCK
WASHER
6. PLAIN
WASHER
7. CAR
BODY
8. REAR SUPPORT STRAP
9. TAPPING
SCREW
10. M5 X 15 HEX BOLT
53mm
182mm
Содержание SCD-5045MR
Страница 2: ......
