Sencor SAC 0910C, Руководство пользователя

Страница: 14 / 32

EN-14
EN
Wall Mounted Split Air Conditioner
SAC 0910C / SAC 0922CH
12/2011 Copyright © 2011, Fast ČR, a.s.
Cooling mode indoors 27 °C (DT) 19 °C (WT) outdoors 35 °C (DT) 24 °C (WT)
Heating mode indoors 20 °C (DT) 15 °C (WT) outdoors 7 °C (DT) 6 °C (WT)
DT – dry thermometer
WT – wet thermometer
3. With respect to continuous development the manufacturer reserves the right to change
technical data without prior notice.
4. Range of operating temperatures:
Maximum cooling Minimum cooling Maximum heating Minimum heating
Inside DT/WT (°C) 32/23 21/15 27/-- 20/--
Outdoors DT/WT (°C) 43/26 21/15 24/18 –5/–6
5. The electrical installation wiring diagram of the air conditioner (for the indoor/outdoor
units) is supplied with the device.
6. If the power cord is damaged, please contact a service technician or a qualifi ed person,
otherwise there is a risk of injury.
INSTALLATION INSTRUCTIONS
1. Locating the indoor unit
• The air inlet and outlet must not be blocked.
• Adhere to the maximum height difference between the indoor and outdoor unit – see
Technical parameters.
• Install the indoor unit on a rigid wall, which can bear the weight of the unit and will not be
vibrated by the unit.
• The unit must not be in direct sunlight.
• Select a location for simple draining of the condensation water and for connection to the
outdoor unit.
• Make sure that light bulbs do not cause interference to the signal transmitted from the remote
control.
• The minimum distance between the air conditioner and a television, radio or another home
appliance is 1 m.
2. Locating the outdoor unit
• Select a location, which can bear the weight of the unit and will not be vibrated by the unit.
• Select a location with good ventilation and low dust level, out of direct sunlight and protected
from the rain.
• Select a location where the air emitted by the outdoor unit or its operating noise level will not
disturb your neighbours.
• There must not be any obstacles in the vicinity of the outdoor unit.
• Avoid locations where fl ammable gas leaks could occur.