10
EN
10.
Adjusting the wraps
By default the machine is set for 3 wraps. Changing
the setting to 2 wraps: Turn off the machine on the
main switch� Press and hold the trigger while turning
on the main switch. The machine is now set for 2
wraps per tie. If the machine is turned off, it will auto-
matically be set for 3 wraps again.
11.
The torque setting unit adjusts the tension of the
ties. 1. digit displays the wrap setting (3 is default)
and 2. digit displays the torque setting.
The torque can be adjusted higher or lower
by
means of the push buttons.
We recommend:
•
2 wraps = position 1 - 5
•
3 wraps = position 6 - 9
12.
Perform a test tie, to check if the torque is set
correctly.
Correct use
1.
Place the arm A unit in a 45° angle over the re-bar
cross surface and push the mouth towards the re-bar
�
2.
Place Arm A perpendicularly on top of the re-bar
cross surface and with the mouth centred over the
cross�
WARNING!
Do not move the rebar tying tool
while it is tying.
3.
The ties should be made in alternating directions�
4.
Cross-tying.
Bend down the knot of the first tie, before you make
the second tie�
How to replace the wire coil.
WARNING!
Set the main switch to OFF po
-
sition, activate the trigger lock and remove
the battery.
1.
Push the release lever until it is caught by the
release stopper�
2.
Remove the wire coil�
Release stopper
Release lever
Wire
Pipe
45°
!
!
!
