Senci AP2000i, Руководство пользователя, Страница: 93 / 108

The Throttle must be "OFF" when using electrical devices that require a large starting current, such as a compressor, pump, or
refrigerator .
NOTE:
LED INDICATORS
The LED Indicators assist in communicating proper and improper functions of the unit.
Output Indicator (Green) The Output Indicator comes on when the engine starts and
produces power.
Overload Alarm (Red) The Overload Alarm comes on when a connected device requires
more power than the generator is able to produce, the inverter control unit overheats , or
the AC output voltage rises above rated values. The Output Indicator (Green) will go off
and the Overload Alarm (Red) will stay on, but the engine will continue to run.
When the Overload Alarm light comes on and power generation stops, proceed as
follows:
1. Turn off any connected electric devices and stop the engine. 2. Reduce the total wattage of connected electric devices within the
rated output. 3. Check for blockages in the cooling air inlet and around the control unit. If any blockages are found remove them. 4.
After checking, restart the engine.
Note: The Overload Alarm may come on for a few seconds when first using electrical devices that require a large starting current,
such as a compressor, pump, or refrigerator. This is normal behavior it is not a malfunction.
Low Oil Alarm (Red) When the engine oil falls below the required level the Low Oil Alarm will come on and the engine will stop
automatically. The engine will not restart until oil is added to the unit to bring it up to the appropriate level.
Note: When starting the unit, if the Low Oil Alarm light flickers and the engine will not start, you will need to add engine oil before
attempting to restart the engine.
Note: Generator should only be operated on a level surface. DO NOT operate the generator on loose ground or obvious inclines.
The low oil shutdown feature may be prematurely activated in these cases causing the engine to not start.
ENGINE SWITCH
The Engine Switch controls the ignition switch. The switch must be in the "ON" position to
start the generator. Switching to the "OFF" position stops the engine and will not allow
the engine to be restarted.
12 V 8 A DC OUTLET
The 12V 8A DC Outlet is for provided for battery charging. Follow instructions in the
owner 's manual for the battery for charging procedures.
8 A DC CIRCUIT BREAKER
The 8A DC Circuit Breaker turns off automatically if the current exceeds 8A. If the circuit
breaker turns "OFF" you will need to push it "in" to turn it "ON" again
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
93