Registering handset for multi-handset system
A. Handset Registration
DO-SO-MI-SO..." sounds from the handset.
(3) The base unit registers the new handset automatically.
When successfully registered, a confirmation tone "DO-MI-SO-DO"
sounds. The amount of handsets used in the system is added by
one automatically.
The ID of new handset is set in sequence and as same as the
amount of handsets used in the system.
When purchasing a new handset, be sure to follow below steps for
registering it.
1. The new handset (non-registered)
(1) Install the battery (P. 9)
(2) Check the handset whether it is a new one or not by pressing
to turn it on.
If the handset can not be turned on, it is a non-registered one.
Do the following steps 2~3.
If the handset can be turned on, it is the one which has registered
to another base unit already. Please do the procedure B (P. 32) to
de-register it first, then do the following steps 2~3.
2. Base unit
(1) Unplug the AC adaptor.
(2) Press and hold on H1 .
(3) Plug in the AC adaptor.
(4) After 3 seconds, a tone "DO-SO-MI-SO..." sounds for 10 seconds.
(5) Release H1 .
3. The new handset
(1) During the tone "DO-SO-MI-SO..." sounds, place the new handset
on the base unit with facing up.
(2) A tone "
31-EN
Your handset(s), if purchased with base unit, is pre-registered at the
factory
