6. The introduction of the parameter setting
6.1 Sensitivity level setting
When the display shows some error codes during the counting, the user can adjust the according sensitivity level
to make the counting more smoothly.
In the normal state, this machine can enter into the sensitivity level setting by pressing the
”
UV
”
and
“
MG
”
at the
same time, and press
“
ADD
”
or
“
BATCH
”
to check each page, then press
“
+
”
or
“
-
”
to adjust the sensitivity level, then
press the
“
RESET
”
to save and exit, the details showed as below:
6.1.1 Voice Switch(optional function):
“
0
”
is VOICE off,
“
1
”
is VOICE on
；
the default is
“
0
”
.
6.1.2 Fake Enable: fake note counted or not counted.
“
0
”
is fake note not counted,
“
1
”
is fake note counted; the
default is
“
0
”
.
6.1.3 Pcs Compare: showing the previous counting number and the current counting number at the same time.
“
0
”
is off,
“
1
”
is on; the default is
“
1
”
.
6.1.4 External port Sel: external display port selection.
“
0
”
is computer communication,
“
1
”
is the 4 digit LED
side d LCD external display; the default is
“
1
”
.
6.1.5 Slant: slant adjustment.
“
0
”
is no adjustment,
“
1
”
is medium adjustment,
“
2
”
is the senior adjustment;
the default is
“
1
”
.
6.1.6 Standby Time: the time of the LCD background automatically off, the default is 3 minutes.
6.1.7 Break Time: the time to stop counting. The range is 10-100ms; the default is 33ms.
6.1.8 Start Val: start sensor sensitivity value, ranging from 0 to 9(
“
0
”
is the lowest,
“
9
”
is the highest); the
default is
“
4
”
.
6.1.9 Reset Val: reset sensor sensitivity value, ranging from 0 to 9(
“
0
”
is the lowest,
“
9
”
is the highest); the
default is
“
4
”
.
6.1.10 Thcount Val: the threshold value of counting tube, ranging from 0-200; the default is 200.
6.1.11 Hole Time: the hole repairing time for the single counting tube.
6.1.12 Lcount Light: left counting tube emitting light value, ranging from 0-99; the default is
“
80
”
.
6.1.13 Rcount Light: right counting tube emitting light value, ranging from 0-99; the default is
“
80
”
.
6.1.14 UV Light: UV emitting light value, ranging from 0 to 99; the default is
“
60
”
.
6.1.15 Double Val: double note sensitivity value, ranging from 0 to 10 (
“
0
”
is off,
“
10
”
is the highest); the default
is
“
0
”
.
6.1.16 Chain Val: chain note sensitivity value, ranging from 0 to 5(
“
0
”
is off,
“
5
”
is the highest);the default is
“
3
”
.
6.1.4 Ext Port Sel: external display port selection.
“
0
”
is computer communication,
“
1
”
is the 4 digit LED side
