EV Charging Station Installation Guide
1
Rev.201901
Safety and Compliance
This document provides instructions to install the SemaConnect™ Charging Station and should not be
used for any other product. This product must be installed in accordance with the National Electrical
Code (NEC) or the Canadian Electrical Code (CEC) whichever is applicable. Consult a licensed
contractor and/or electrician before installation to ensure compliance with local building practices,
climate conditions, safety standards, and state and local codes.
Under no circumstances will
compliance with the information in this guide relieve the installer of responsibility to comply with
all applicable codes and safety standards.
This document describes the most common installation and mounting methods. Contact SemaConnect
where it is not possible to perform an installation using the procedures provided in this document.
SemaConnect is not responsible for damages that may occur during or as a result of installation.
IN NO EVENT SHALL SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS BE
LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL, PUNITIVE, OR CONSEQUENTIAL
DAMAGES, INCLUDING WITHOUT LIMITATION, LOST PROFITS, LOST DATA, LOSS OF
USE, COST OF COVER, OR LOSS OR DAMAGE TO THE SEMACONNECT™ CHARGING
STATION ARISING OUT OF OR RELATING TO THE USE OR INABILITY TO USE THIS
GUIDE, EVEN IF SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS HAVE BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
SemaConnect™ Charging Station is a trademark of SemaConnect, Inc. All other products or services
mentioned are the trademarks, service marks, registered trademarks or registered service marks of their
respective owners.
Copyright ©2019 SemaConnect, Inc. All rights reserved.
This material is protected by the copyright laws of the United States and other countries. It may not be
modified, reproduced or distributed without the prior, express written consent of SemaConnect, Inc.
