SEM The Vending Tester PRO CT3, Инструкция по эксплуатации

Страница: 22 / 32

22
Simulator mode
Vend price A: $xx.xx
Simulator mode
Vend price B: $xx.xx
Simulator mode
Vend price C: $xx.xx
** Simulator mode **
Release button
Simulator mode, MDB level, Scaling Factor & Decimal point
Simulator mode
The CT3 comes with a vend simulator. This is useful if you want to test
more than one device at a time such as a coin changer and a bill accep-
tor and even a cashless system. The simulator mode only works with
MDB devices. You cannot connect more than one identical device at a
time such as two coin changers for example. The maximum set-up you
can have is one coin changer, one bill acceptor, and one cashless de-
vice.
Before entering the simulator mode, you may need to program the
price of your selections. The CT3 offers you three selections identified
by the buttons A, B, and C.
They are programmable. To view the price of each selection, simply
press on the corresponding button. The display will prompt you Simu-
lator Mode Vend Price A: $xx.xx. Do the same for selection B and C. If
you want to change the price, press and hold that selection for few
seconds. The display will then prompt you
Programming: Vend Price
A: and the price will drop to $00.00 and flash. Each time you press on
the button, the price will go up by increments of 5¢. If you go over
your price, press on the red button to decrease. If you want to set a
very high price, press on the red button to go backward. It will be
faster. Maximum is 12.75$. Once the your price reached, press on the
green or blue button. Programmed will appear on the display.
To enter the simulation mode, press and hold the START button until
the display prompts you to release the button. Note that some MDB
peripherals do have a long response time, longer than the timeout of
the CT3. Keeping the START button depressed will disable the timeout.
You can perform sales. Insert any money. Press on a selection button.
See if the proper change is returned. With cashless systems, you can
add value to the card using the simulator mode. To exit, press STOP.