6
OPERATING Cont…..
Starting the Machine
Do not shred any material which may loop or splinter. Material, which
does not go through the cutting head can only be pushed in with the
pusher (9). In case of danger, press emergency off button (8).
•
Turn main switch (6) into position “I”
•
Emergency button (8) must be unlocked (turn to the right)
•
Turn on the key switch (4) turn to the right then the standby (5) illuminates
•
Press and release the black button (1) conveyor belt is running
•
Feed the paper over the total width of the conveyor belt
In case the quantity of material inserted is increased, the machine automatically changes to a more powerful and
slower function. If this performance is still not sufficient the machine starts to reverse shortly and afterwards
runs again forward. The machine switches between both speed levels until all material inserted is fully
destroyed.
Attention!
If possible let the machine work at its normal speed.
Shred continuous paper only in stacks
Stopping the machine
•
Press the red key (2) or press the emergency “OFF” button (8)
Keep hands away from the running shredding mechanism!
•
Yellow pilot light (7) appears, temperature of motor is to high
(Decrease the material on the conveyor belt to make the machine work in normal speed)
•
Yellow pilot light (7) lights up, temperature is too high(wait approximately 10 to 20 minutes until motor
cools down)
Stopping the Machine
For short breaks
•
Press and release the red button (2) conveyor belt stops
For longer breaks
•
Turn the main switch (6) to position ”O” the entire machine shuts down
•
Turn the key switch (4) and remove the key-now the machine is secured
from unauthorized use
Changing the Waste Bag
If the lamp waste bag full lights up you should empty the waste bag.
•
Open the door (9)
•
Pull out the waste bin from the machine
For NATIONWIDE SERVICE Call 1(800)225-9293
6
