SELWOOD S3 Part 1 -Window Wall Assy
Step 3: Window Wall Assembly
Complete Window Wall Assembly on both sides of fort.
If a Selwood Spiral Slide or Selwood Monkey Ladder were purchased complete only one Window Wall
Assembly then proceed to Step 4 for the second Window Wall Assembly.
A:
From inside the fort measure 13-1/8” from the Half Wall side (F13) Post and then attach (A11) Long Wall
Support to (F17) End Floor and (F16) SW Ground/(F8) SL Ground with 4 (S1) #8 x 1-1/8” Wood Screws per
(A11) Long Wall Support. (fig. 3.1, 3.2 & 3.3)
B:
On the outside of the fort and tight to the top of (F16) SW Ground and (F8) SL Ground attach (A7) Long
Trim to each (F13) Post with 4 (S2) #8 x 1-1/2” Wood Screws. The (A7) Long Trim should overhang and be
flush to the outer most edges of the siding. (fig. 3.1 & 3.2)
C:
Tight to the top of (F16) SW Ground attach (A15) Short Trim to the Half Wall Side (F13) Post with 3 (S2)
#8 x 1-1/2” Wood Screws so the trim overhangs and is flush to the outer most edges of the siding. (fig. 3.1)
Note: Only 1 side will need (A15) Short Trim installed. In Step 1 cont. one (A15) Short Trim was already
installed
.
Hardware
Wood Parts
2 x
Long Trim 1 x 2 x 38-3/4”
2 x
Long Wall Support 1 x 5 x 46-1/4”
1 x
Short Trim 1 x 2 x 19-5/8”
A7
A11
Fig. 3.1
Slide
removed
for clarity
18
Fig. 3.2
Inside Fort View
Outside Fort View
F13
F13
A11
A11
A7
F16
F17
S1
S2
S2
S1
13-1/8”
A15
A15
8 x
#8 x 1-1/8” Wood Screw
11 x
#8 x 1-1/2” Wood Screw
S2
S1
A11
F8
Fig. 3.3
S2
F17
F8/
F16
13-1/8”
F13
Wall Assembly
Outside Fort View
Swing Wall Assembly
A7
