EN
43
commeo initial operation/setting by radio
Note for settings under point 6.2.: The motor must be selected for this setting with a trans-
mitter in SELECT mode (Status LED flashes slowly in orange). After completing the setting,
the motor is still selected (see point 6.).
6.2.1. Automatic setup-mode, deletion and automatic setting of the end positions
in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup-mode. Motor types SE Pro-com will automatically find their stop positions. For this, a
motor must first move against the upper stop and then downwards until it switches off auto-
matically.
Operation
Drive
9 s
Press the STOP button of the transmitter for 9 seconds.
Both limit positions already set will be deleted.
Note: Not required for the initial installation or after
resetting to factory defaults.
or
STOP
STOP
Move the motor upwards with the UP or DOWN button.
Auto-Stop top
and bottom, keep
motion button pressed
The motor moves against the upper stop and stops
automatically. The correct direction of rotation assign-
ment has been made.
Continue to keep the button pressed. The motor auto-
matically moves downwards after 1–2 seconds. Alterna-
tively move the motor downwards using the DOWN
button.
Note: The motor can be moved upwards and down-
wards. As long as the lower end position has not been
found, the downwards moving will be interrupted
twice.
The motor will reach the lower limit and stops automa-
tically. The end positions are now set and the rotation
direction assignment is correct. Perform a test run.
Note: The transmitter may not yet have been program-
med. See point 6.2.4. to program a transmitter.
