32
EN
commeo initial operation (by radio)
6. commeo initial operation (by radio)
commeo initial operation
The commeo initial operation is only possible using commeo transmitters. To com plete
the settings in the receiver, the receiver must be selected with a trans mitter in
SELECT
mode. In
SELECT
mode, there is only one connection at a time to a re ceiver. Only this
one can be moved and set.
6.1. Selection of a receiver
By pressing the
SELECT
button for 3 seconds the transmitter will be put into the
SELECT
mode. After the
SELECT
mode has been started, the status LED will start to
flash quickly and the transmitter will look for the receiver. The status LED being lit in
green indicates that the receiver has been found and the status LED will flash slowly in
orange. The first receiver completes a brief confirmation run. If no receivers have been
found this will be indicated by the status LED being lit in red.
Receiver selection with non-programmed transmitter/initial operation
1. Interrupt the voltage supply of the receivers for
> 1 second. The receivers can be found within the next
4 minutes.
2. Push the
SELECT
button at the transmitter for 3 seconds.
The transmitter is in
SELECT
mode.
or
Receiver selection with programmed transmitter
1. Select the transmitter channel on which the receiver is programmed.
2. Push the
SELECT
button at the transmitter for 3 seconds. The transmitter
is in
SELECT
mode.
Note:
The receivers found by this method can now be found using another non
programmed transmitter within 4 minutes. Press the
SELECT
button on the additional
transmitter for 3 seconds for this purpose. The transmitter is in
SELECT
mode. All
settings can now be completed with both transmitters.
6.2. Programming/deleting transmitters
To program or deprogram a transmitter, select the desired channel and push the
PROG
button for 1 second. The status LED lights up green to indicate that the transmitter has
been programmed. A red light means that the transmitter has been deprogrammed.
3 s
➧
3 s
>1 s
1 s
Status LED transmitter = green
transmitter programmed
Status LED transmitter = red
transmitter deleted
