iveo Heat Connect
2015-May, 06 – Rev_00
23/36
Step 2
Push the PROG button at the transmitter to be programmed for 3 seconds.
The new transmitter is now programmed in the
iveo Heat Connect
.
A connected heating is briefly switched on and off (only for infra-red heatings with visible
light).
10.
Reset receiver to factory settings at iveo plug or iveo-Heat
Factory settings means that no transmitters and no intermediate positions are programmed at
the
iveo Heat Connect
any more.
Observe that the following mains separation is only performed at the receiver that is to be
reset to factory settings.
Note:
If several receivers are switched in parallel, they are switched to service mode at the
same time when the mains is disconnected (step 1). After pushing the PROG button for
9 seconds (step 2), all receivers are reset to factory settings.
Step 1
Perform mains disconnection according to the figure
A connected heating is briefly switched on and off 2 x (only for infra-red heatings with visible
light).
Step 2
Push the PROG button at the transmitter to be programmed for 9 seconds.
All transmitters are now deleted from the iveo Heat.
Factory settings are set.
Note:
Service mode can be ended by a running command (UP or DOWN button) of a
programmed transmitter.
11.
Maintenance, care, cleaning
The
iveo Heat Connect
is maintenance-free.
Check for damage at least once per year. Special care is not required.
Power down the
iveo Heat
Connect
for cleaning.
Take safety measures against inadvertent activation.
Use a moist rag for cleaning.
Do not use any cleaning agents or solvents.
