ENGLISH - 19
D-3
Place the assembled cable holder inside the tape
marking and drill three(3) of 2mm holes
Fix cable holder on the vehicle roof with
three(3) of M4 x 20 screws on drill holes made
D-6
D-5
Apply silicone around cable holder and on the
top of screws for waterproof
Connect cables to the ports of the antenna ,
remove masking tape and tidy silicone before dry
D-8
D-7
Set up the signal cable, cable holder and cable
gland as above picture
D-1
D-2
Apply masking tape 5mm from away the
outside of holder and drill a 20mm hole in the
center to allow the cable can pass through.
D. Cable holder installation
approx. 30cm
Insert the signal cable through the hole
D-4
Arrange cable holder in front of (30cm apart
from) antenna center by facing open side of
cable holder. Then attach masking tape
outside of cable holder
