Control Remoto Inteligente Universal
7
about every 1.5 seconds again to search the next reactive
code (continues the Manual Search, see step 4-5).
If you feel most of keys on the remote control work good
enough, you can save the code by pressing the device key
(e.g. TV) to finish the Manual Search.
Remark:
1.The Manual Search will be automatically terminated if
no entry within 30 seconds.
2. The “Manual Search” will be terminated automatically
after it goes through all codes and LED will light off. But
you can start it again if necessary.
D.
Set up by Learning:
The LEARN function is used to supplement the
preprogrammed codes. The standard code list may
provide most of functions needed, but you can add a small
number of additional functions on it. Or you can add a
new code from a original remote control which is
shortage in the code list.
In learn mode, you must prepare a another original remote
control where you will take codes from.
Please use fresh batteries for both the Learning Remote
Control and the Original Remote Control.
1.Press down and hold the Learn key and press the device
that you want to learn(e.g. DVD), then release the both
pressed keys. The DVD device button on your new
remote control blinks and then the remote control is in
learning mode for DVD codes.
2. Press and release the target button that you want to
learn to (e.g.POWER), the device button lights up.
3. Point the original remote control to the receiver LED(as
the same as it’s transmitter LED) on your new remote
control, both remotes facing each other by approximately
30mm apart.
