MANUAL DE INSTRUCCIONES CODIGO 80222 REV A NOV-2007
(Sujetas a modificaciones sin previo aviso)
Page: 15
J
.P. SELECTA s.a.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: www.jpselecta.es
7 Installation
7.1 PLACEMENT
Place the piece of equipment near of a socket keeping in mind the its
amperage on a leveled surface enough resistant to support the weight
indicated on the table of the section 3 (Technical features), leaving and
space of 10 cm by the rear part and both laterals. If it is a table make sure
that its legs are able to absorb the centrifuge vibrations.
7.2 POWER SUPPLY CONEXION
Make sure that the voltage of given by the socket is the indicated on the feature
label attached on the rear part .
Do not use the equipment unless it is correctly earthed.
If you replace the plug keep in mind the following:
Blue wire:
Neutral
Brown wire:
Phase
Yellow/green wire:
Ground
DO NOT INSTALL THE CENTRIFUGE IN AREAS WHERE INFLAMMABLE
LIQUIDS ARE STORED OR SPECIAL PROTECTION AREAS.
7.3 PLACEMENT
• Place the piece of equipment near of a socket keeping in mind the its
amperage on a leveled surface enough resistant to support its weight.
• The surface of placement must allow the sticking of the legs of the
centrifuge.
• Left a free spece of 30 cm around the piece. (See danger indication)
• This kind of equipment may produce vibrations which could affect nearby
equipment.
FREE SPACE AROUND
THE CENTRIFUGE
Safety zone:
Leave a free space of 30 cm
around of the centrifuge.
When the centrifuge is working:
• Do not place dangerous products
in the safety zone.
• The personnel must be out of
safety zone.
DO NOT INSTALL THE CENTRIFUGE IN AREAS WHERE INFLAMMABLE
LIQUIDS ARE STORED OR SPECIAL PROTECTION AREAS.
