MANUAL DE INSTRUCCIONES
CODIGO 80014 REV E
01/2022
Pag.: 23
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: http://www.grupo-selecta.com
8.6 How to change from long to short stroke in shaker move-
ment
* Remove the platform by unscrewing the 4 Allen screws (and 4 washers)
with a 5mm Allen Key.
* Loosen and remove the nut and collars of the eccentric shaft 4 with a
10mm key.
* Remove P2 piece from its housing 3 and 4.
* With a 14mm key, loosen and remove the hexagonal extension of shaft
4 and place it in the nearest thread hole to the centre of the shaft.
* Place P2 piece between 3 and 4, trying to keep its initial position (swinging
collar in 3 and the cavity produced by the thickness difference between
the piece and the radial bearing at the top).
* Place the short collar in 4.
* Place the long collar in 4.
* Screw the nut on shaft 4 and tighten slightly with a 10mm key.
* Replace the platform and tighten the 4 Allen screws with their washers.
The cavity produced because the
thickness difference is on the top
part
Notice to customers:
The product is made up of various components and various materials that must
be recycled or, failing that, deposited in the corresponding debris removal sites
when the product’s life has been completed or when otherwise it is necessary
to dispose of it. To do this, the end user who acquires the product must know
the current regulations of each municipality and / or locality based on the waste
electrical and electronic equipment. The user who acquires this product must be
aware of and responsible for the potential effects of the components on the envi
-
ronment and human health as a result of the presence of hazardous substances.
Never place the product in a conventional container of citizen scope if a previous
dismantling and knowledge of the components that incorporates. If you do not
know the procedure to follow, consult with the city council for more information.
