MANUAL DE INSTRUCCIONES
CODIGO 80382 REV B
02/2021 Pag.: 10
J
.P. SELECTA s.a.u.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: www.grupo-selecta.com
Be sure that the voltage supply is the same as the one indicated
on the characteristics plate.
Do not use the equipment if it is not earthed.
If you have to change the plug cap, bear in mind the following:
Blue cable:
Neutral
Brown cable:
Phase
Yellow/green cable: Earth
STARTING UP THE RECORDER
1. Open the recorder lid by using the key
2. Remove the needle
3. Unscrew the shaft handle and remove the paper
4. Pull out the shaft to remove the recorder
5. Insert the battery into the rear part
6. Insert the recorder again
7. Put the needle again
8. Close again the recorder lid
Use a good quality alkaline battery to ensure a duration of more than
6 months.
MAINTENANCE
Before removing the casing, disconnect the equipment from the
mains.
The manipulation of the internal electronic circuits of the equipment
by unqualified personnel can cause irreparable damage.
Be sure that the equipment is repaired by a J.P.SELECTA authorized
technical service.
BASIC MAINTENANCE
- Change recorder battery every 6 months (see “installation”)
- Change recorder paper every week (see “installation”)
- Change pen from recorder every 5 years (90 meters)
- Clean the evaporator of the cooling group at least once a year.
CLEANING
Use alcohol with a non abrasive cloth for the cleaning of the different
pieces of stainless steel and plastics.
