NR-
Operation Manual
10
Antenna module can be adjusted in two axes.
NOTE: Loosen antenna joint pivot screw before antenna
module adjustment (fig. 3).
To adjust telescopic arm length unclamp its level locks.
NR-T Control unit
(fig. 4) is placed on top of the telescopic bar and
in essence consists of LED display for representing an acting
operational mode and received signals level as well as control board
with 7 non-fastening buttons that are used for adjusting and altering
A/M operational modes.
ATTENTION! Don’t disconnect Control unit cable from
the Main unit jack (item 7, fig. 2) during operation.
Fig. 3 – Antenna module
Joint pivot screw
for antenna module
swivel adjustment
Level-lock
for antenna module
adjustment
Two level-locks
for telescopic arm
adjustment
