4 Preparation for Plotting
Prepare for plotting according to l,he following procedure.
D
2)
(1)
(2)
Paper holder
Installation
Install the X Y plotter in as flat a place as possible.
Paper setting
Magnetic Paper Holding type.
Raise the paper holder,and insert the left edge of the sheet of paper.
The left edge meets the paper guide. At this time, the bottom edge
of the paper should be even along the guide rail. Secure the right
side with a magnet.
Electrostatic Paper Holding type.
Push PAPER HOLD key on the control panel and confirm if
lamp is on. This light shows that the function of electro-
static paperhold works effectively.
Paper should be so set that its left edge shall fit to the left end of
the plate and its bottom edge to the guide seal. In this case, a
binding margin of approx. 12mm
width is reserved on the left edge of
paper, and this marginal space is free from the effect of electrostatic
absorption.
If the paper waves on the plate, make it even by the palm of hand.
By pushing PAPER HOLD key again, P. HOLD lamp is turned
off, and absorption is released.
P•per guide
Guide seal
P•per
Guide seal
P. per
P.p.r bolder
Paper
.jong
guid•
•ions guide
Magnetic Paper Ilolding CY1)e.
Electrostatic Paper Holding type.
6
