EM00136299
rev. 1.0 IT
13
Paragraph 13 – Password
Programming
Operation
PROG
Config.
+
Password
****
Password
0000
By setting the password, the programming section can be
accessed to view all the setup parameters, but every time
you try to change the settings you will be prompted for the
password.
The flashing line indicates the editable number; press
to select the number (from 1 to 9), then press
to select
the number to modify, and then press
to confirm. By
setting “0000” (default), the password will be eliminated.
Paragraph 14 – Flow Alarm
Programming
Operation
PROG
Config.
+
Alarms
Flow
Flow
Off
Flow
On
Signals
6
Alarms
Flow
Allows you to activate (deactivate) the flow sensor.
Once activated (On) by pressing the
key, you can set
the number of signals the pump requires before starting the
alarm (by setting the Time = 0 s on the next menu) or the
priming (by setting the Time different from 0 s in the next
menu). Press
and the number will start to flash, than
press
to set the value.
Press
to confirm then press
to return to the main
menu.
In the Time menu you can set the time over which the pump,
not having received the flow signal for the set number of
signals, will start priming before starting the alarm. If during
the priming the pump receives again the flow signal, it will
return to normal operation. For the time = 0 s, after the set
number of signals, the pump will start immediately the alarm,
without performing the priming. To set and modify the time:
press
and the number will start to flash, than press
to set the value. Press
to confirm then press
to return to the main menu.
Only in Batch mode you can activate the Recovery mode.
The pump repeats the number of strokes not detected by the
flow sensor. Press
to access the request of the
maximum number of signals that the pump can recover
before starting the alarm. Press
and the number will
start to flash, than press
to set the value. Press
to confirm then press
to return to the main menu.
