To fit seat, slide
seat down onto
stainless steel
pins.
To remove seat,
put the seat
in the upright
position and
pull upwards.
6
Fixing the cistern to the pan
6.1
First check the alignment of the cistern and pan attachment holes —
place the cistern onto the pan and ensure that the holes align. The
back of the cistern and pan should line up so that the assembled toilet
suite will align with the wall. Now remove the cistern.
6.2 Place the
rubber seal
onto the plastic pipe outlet at the base of the
cistern and ensure it is securely attached. Locate the cistern outlet
(with rubber seal) onto the pan, ensuring a good fit.
6.3
If using bottom entry inlet
, connect the flexible inlet hose (see
Step 3.1) to the cistern’s water control valve on the base of the cistern.
(Ignore this if using back entry connection.)
6.4 Now secure the cistern to the pan using the two
bolts with seals
in
the cistern/pan attachment holes.
6.5 Flush the lines and connect the water supply and check the operation
of the cistern.
7
Fitting the cistern lid
7.1
Fit the
flush button
into the cistern lid, with the half flush on the left
and full flush on the right. Ensure that the rubber feet of the flush
button connect and line up correctly with the flush valve inside the
cistern. Fit the
cistern lid
and push the buttons to check operation.
8
operation and maintenance
8.1
Press the left side half flush to save water and the full flush as
required. Clean the toilet with liquid detergent and a damp cloth.
8.2 Do not place water additives inside the cistern as this may have
chemicals that damage the valves and impair the functionality of the
cistern.
9
seat installation instructions
9.1
Secure the toggle bolts into the seat connection holes, ensuring that
the stainless steel pins line up with the receptor holes in the seat.
Once correctly placed, ensure that the bolts are properly tightened.
9.2 Slide the stainless steel caps onto the plates with pins.
9.3 To fit the seat, slide it onto the stainless steel pins. If you need to make
adjustments to position the seat correctly, go back to Step 9.1.
9.4 To remove the seat, put seat in upright position and pull the seat
upwards.
bottom entry port hole for
flexible hose (available both
sides of pan)
bracket fixing holes (both
sides of pan)
cistern/pan attachment
holes
seat connection holes
cistern outlet pipe hole
bottom entry port hole
(available both sides of pan)
diagram d
Page 4 of 4 | seima.com.au
