Chapter 2
Getting Started
User Guide
2-7
Loading a Roll of Labels
Follow the instructions below to load a roll of standard
address labels.
Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of
labels.
Note...
Check to be sure there is a black sensor mark on
the label backing as illustrated on page 2-3.
2 If needed, cut between the labels to create a “leader.”
If the end of the roll is not prepared as shown above, cut
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and that the
printer is turned on.
The green status light should be flashing.
2 Lift the base of the clear plastic label cover and rotate it
open.
Roll
Prepared end
Cut here
Roll
Waste
Label
Cover
Spindle
100-200book.book Page 7 Thursday, July 13, 2000 12:14 AM
Содержание SLP100
Страница 10: ...Chapter 1 User Guide 1 1 Introduction About Your Smart Label Printer 1 2 Software Features 1 3...
Страница 33: ...Appendix B User Guide B 1 Commonly Asked Questions and Answers...
Страница 35: ...Appendix C User Guide C 1 Technical Support and Service...
Страница 37: ...Appendix D User Guide D 1 Ordering Labels and Parts...
