Cal. 5T82A TEC HNICA L GU IDE
21/26
No.
PROCESS
SPECIFICATIONS (QUALITY SPECIFICATIONS,
HANDLING METHODS ETC.)
ILLUSTRATIONS AND SPECIAL INSTRUCTIONS ETC.
43
Remove the
winding stem.
Pull out the crown temporarily to the first click position when removing
the winding stem.
Set the movement
with dial and
hands into the case.
Remove dust and dirt on the movement with dial and hands and inside of
the case before casing
43
Set the winding
stem.
1
Set the buttons.
(2 pieces)
*1
Only some models require this process. Whether a watch requires this
process or not depends on the design of its case.
10
Set the antimagnetic
shield plate B.
Make sure that it is securely set in the correct direction.
Close the case
back.
43
Be careful so as not to deform the winding stem conducting spring of the circuit block cover while
removing or installing the winding stem.
43
Set the winding stem.
For a watch with a screw lock type crown, apply silicone grease (100,000 to 500,000 c.s.) to the point
of contact between the winding stem and gasket of the crown.
A sufficient amount of silicone should be applied so that the entire surface becomes wet. (See the
illustration below.)
10
Set the anti magnetic shield plate B.
Close the case back.
Make sure that the circuit block cover is securely hooked before closing the case back.
Crown
