6
General instructions for installation and operation of the ignition and associated parts:
The receiver (RC equipment) must be installed at least 20 cm from the igniton and their
power source.
All cables should be mounted in such a way that they do not come with the muffler or
any other part of the engine in contact, which may become hot. Otherwise, the
insulation could be damaged, which may cause a short circuit and therefore to the loss of the
model.
Do not attach pliers or other tools to remove the spark plug cap. Do not pull the plug wire, but
remove the spark plug by a slight rotation by hand.
Keep a firm hold of the spark plug cap, otherwise known as crack pulses may arise , which
would affect the remote control of your model.
A slight clicking shows you the correct position of the connector on the spark plug.
Please also refer to the operating instructions of the ignition system.
6 Fuel mixture
We recommend for your engine unleaded fuel with an octane rating of 98 or more, and oil
additive or a finished two-stroke engine mixture (e.g. Aspen 2 or Motomix).
As an oil additive to the unleaded petrol Stihl Engine Oil HP Ultra or Castrol RS 2T You can ,
for example, Stihl HP motor oil , engine oil Stihl HP Super , use . All of these oils are fully
synthetic two stroke oils. The brand name may vary in your region.
6.1 Mixture table
Petrol
Fully synthetic oil
Run-in period
1 liter
0,02 liter (2%)
Flight and continuous
operating
1 liter
0,02 liter (2%)
The run-in period should last for two hours. Within this time you should never run the
engine with more than 75% throttle position. Please note for this also the operating
instructions supplied with your remote control, servo travel section and throttle curve.