Rapid 220 - Site Preparation Guide
Rapid 220 Site Preparation Guide
14
Technical specifications
Tab. 1 Rapid 220: Technical specifications
ELECTRICAL RATING
Electrical Power supply:
230 Vac +15% -10% 50-60 Hz 12 A
Absorbed power:
2500 VA
Power Cord
PVC 600V 90°C 3xAWG12 section for 230 VAC
To be fitted with plug series 60 IEC 309 2P+
50-60 Hz ±15%
IP44+1P+N+T
Power supply plug:
Series 62 IEC 309 2P+
50-60 Hz ±15% IP44 230 VAC
AIR SUPPLY SPECIFICATIONS
Air supply:
Filtered at 3
μ
m
99.9% of the oil must be filtered from air
The air must be dried with a dew point of 10
°Celsius
Air consumption:
1.5 l/cycle(**) or ~100Nl/min
Air Input
3/8’’ female with GAS threading
Air hose to system
3/8’’ ID minimum
Pressure adjustment
Typ. 5 Atm, Max. 7 Atm
Max. air compressor
capacity
10 l/m
AIR SPECIFICATIONS
Air features
The system must be supplied with air not containing particles whose size
is greater than 5 µm. 3 µm microfiltration is recommended.
The air should be dry enough as to prevent formation of water
condensation in the ducts and mechanical parts of the system.
The air shall not contain oil vapors that can result in accumulation of oil in
the air distribution system.
Air quality classification
The quality of compressed air must be compliant with
ISO 8573-1: 2010 [2:4:3]
Dirt (solid particulates)
Water
Oil
Max. number of particles per m
3
Particle diameter (d) dimensions in
μ
m
Vapor
pressure
dewpoint
Total oil
0.1<d
≤
0.5 0.5<d
≤
0.1 0.1<d
≤
0.5
°C mg/m
3
≤
400 000
≤
6000
≤
100
≤
+3
≤
1
WARNING: The Rapid 220 is factory-adjusted for operation at 230V, voltage change-over
in the field, should be done only by factory-trained service personnel. If
not warranty may be voided.
