Phillip head screw
Anchor
3.
At least one of the screw
must be inserted into a wall
stud.
Measure the wall and
mark the location of the
center of each of the three
screw mounting holes. See
Figure 2.
Using the level, make sure
that all three marks are level
on the wall.
4.
Using the power drill and
1/4
″
drill bit, drill three 1/4
″
holes through the wallboard
at the mounting hole marks.
NOTICE
Make sure not to drill into
electrical wiring or plumbing
pipes.
5.
Insert one of the furnished
plastic anchors into each of
the three 1/4
″
holes. See Figure 3. Make
sure that the wall anchor is
flush with the wall.
NOTE
: It may be
necessary to use a small
hammer to gently tap the
anchor into place.
6.
Using the Phillip head
screwdriver, install one Phillip
head screw into each of the
anchors as figure 3 shown.
Turn the screw in until there
is a gap of 1/4
″
between the
head of screw and the wall
surface.
Figure 2 – Screw Hole Location
Figure 3 – Wall Anchor Installation
1/4" Gap
1/4" Hole
Drill three 1/4”
holes into wall.
