SEH FC1126, Руководство пользователя

Страница: 23 / 40

User Manual [en] 20
5. Screw the Fiber Adapter to the panel with the enclosed short screws
(M3 × 5 mm).
Installation with Adaptor
1. Carefully pull the RJ-45 cable slightly out of the Fiber Adapter.
2. Connect the included USB cable (mini-B connector) to the USB connector of
the Fiber Adapter.
3. Thread the enclosed USB cable through the oblong hole in the adaptor.
4. Thread the RJ-45 cable through the oblong hole in the adaptor.
5. Position the adaptor over the Fiber Adapter:
– The little wings of the adaptor go into the Fiber Adapter.
– The holes of the adaptor and Fiber Adapter are congruent.
– The USB cable is threaded though the oblong hole in the adaptor.
– The RJ-45 cable is threaded though the biggest hole in the adaptor.
6. Thread the unconnected end of the USB cable (connector A) from the out-
side through the cut-out in the panel and make sure it does not touch the
printer mainboard.
7. Connect the RJ-45 network cable of the Fiber Adapter to the RJ-45 network
connector of the printer.
8. Place the Fiber Adapter from the outside above the cut-out in the panel. The
holes of the Fiber Adapter and the holes next to the cut-out must align con-
gruently.
9. Screw the Fiber Adapter to the panel with the enclosed short screws
(M3 × 20 mm). The screws must go through the adaptor into the holes of the
WARNING
Incorrect positioning may impact the Fiber Adapter's
security against interception!
Position the Fiber Adapter as described and make sure
that the RJ-45 connector and the panel cut-out are
completely covered.
WARNING
The RJ-45 cable and USB cable may be damaged if
pinched!
Make sure that your cable management does not pinch
or squeeze the cables.
WARNING
The Fiber Adapter circuit board may be damaged if it is
touched by the adaptor!
Position the adaptor very carefully on the Fiber Adapter,
so that adaptor and circuit board do not touch.