SEH FC1126, Руководство пользователя

Страница: 22 / 40

19 [en] User Manual
Step 3: Prepare the Printer Mainboard
The printer mainboard panel features a pre-punched metal cut-out and holes
near the RJ-45 connector.
1. Identify the pre-punched metal cut-out and holes.
2. Depending on printer model, the metal cut-out is concealed on the circuit
board side by a hard disk drive. If this is the case, remove the hard disk drive.
If the hard disk drive is equipped with a fan, unplug the fan cable from the
printer mainboard first. Refer to the documentation of your printer on how
to do this.
3. Remove the panel film around the RJ-45 network connector so that the cut-
out and the holes are free and that there is no film between the panel and the
Fiber Adapter in its final position.
With some printer models, the protective film consists of perforated parts that can be re-
moved individually. With printer models without perforated parts you have to cut the film on
your own with a utility knife.
4. Remove the pre-punched cut-out. To do this, insert a flat screwdriver into the
elongated hole at the cut-out and carefully remove the cut-out by levering it
back and forth.
Step 4: Installing the Fiber Adapter
The exact mounting position of the Fiber Adapter varies depending on printer
model. In addition, some printer models need the enclosed adaptor.
Installation without Adaptor
1. Connect the included USB cable (mini-B connector) to the USB connector of
the Fiber Adapter.
2. Thread the unconnected end of the USB cable (connector A) from the out-
side through the cut-out in the panel and make sure it does not touch the
printer mainboard.
3. Connect the RJ-45 network cable of the Fiber Adapter to the RJ-45 network
connector of the printer.
To make things easier, you can gently pull the RJ-45 network
cable out of the Fiber Adapter. After connecting the cable, put
it back into the housing of the Fiber Adapter.
4. Place the Fiber Adapter from the outside above the cut-out in the panel. The
holes of the Fiber Adapter and the holes next to the cut-out must align con-
gruently.