
Wheel Insert Replacement Instructions
©2005 Segway LLC
Page 2 of 3
18987-00001aa
Fender Tab
Remove the Tire/Wheel Assembly
Step 1
Tip the Segway HT onto its side so
that the outside of one wheel lays flat
against a clean, smooth surface
Step 2
Remove the Wheel Nut with a 16 mm
deep socket wrench. Hold the wheel
from rotating and turn the wrench
counterclockwise. (This may require
considerable force.)
Step 3
Strike the outside edge of the tire with
a rubber mallet to unseat the wheel
hub taper. (This may require multiple
attempts as the wheel hub is seated
tightly into the Gearbox taper.)
Step 4
Lift off the wheel.
Step 5
Clean any debris from inside of
Gearbox taper and outside of wheel
hub.
Remove the Splash Guard
Step 1
Remove the two Splash Guard
fasteners using a T-20 six-lobed bit
(Torx T-20).
Step 2
Remove the two oblong Fender Tabs
that are between the fasteners and
the Fender, and save these for reuse
when you install the Splash Guards.
Step 3
Remove the Splash Guard