Sega Virtua Tennis 4, Руководство пользователя

Страница: 15 / 136

6
PRECAUTIONS REGARDING INST
ALLA
TION LOCA
TION
2
Securing a safe area for operation as described in this manual will ensure
safe operation for players and observers.
SEGA shall not be held responsible for damage or compensation for damage
to a third party, resulting from the failure to observe this instruction.
● For safe operation, use and operate this product in an area measuring at least
1.16 m (45.6 in) in width and 104 m (55.3 in) in depth. SEGA shall not be held
responsible for damage or compensation for damage to a third party, resulting
from the failure to observe this instruction.
● The ceiling where this product is installed must be at least 2.30 m (92.5 in) high.
If the ceiling is too low, the heat emitted from the product may cause it to catch
on fire.
● Be sure to provide sufficient space specified in this manual. Do not allow objects
to block the ventilation ports. It can cause generation of heat and a fire.
● Put the cabinets close together so that people cannot get through or provide
enough space between them that people can go both ways without difficulty.
If the cabinets are installed carelessly, people may bump into each other or
the cabinets when passing between them or fall down. To prevent people from
walking between them, place them 0.15 m (5.9 in) apart.
● If the machine does not fit through the entryway to the installation location,
do not disassemble it without first consulting the instructions. Specific tools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine without
consulting the instructions may result in accidents during assembly/disassembly
and electric shock, short circuits, and/or personal injury during operation. If the
machine still does not fit through the entryway after following the procedures in
this manual, contact your retailer or the office listed in this manual.
● If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation.
● To install this product, the entrance must be at least 0.87 m (34.2 in) in width
and 1.80 m (71 in) in height. (without Billboard) If the entrance is too narrow, do
not tilt the product carelessly. If all the product weight is put on the casters at
one side only, there could be damage or deformation, causing serious accidents
such as workers getting caught underneath.
OPERATION AREA (SINGLE CABINET)